Electrician Near Me in Wichita, KS | Same Day & 24 Hour Service

Most electricians in the area work off an hourly rate of roughly $50 to $130, often with a service call fee of about $100 to $200 that covers the first hour. We do things a little differently. For most jobs you get a flat rate quote up front, so you know the full number before we start instead of watching a clock run. Small jobs like an outlet or a light switch land on the lower end, while bigger work like panels or rewires is priced by the job.

It depends on a few things: the condition of your existing wiring, whether your meter base needs replacing, how far the panel sits from the meter, and the permit fees through MABCD. Most straightforward upgrades from a 100 amp panel to 200 amps fall in a predictable range, and we give you the exact figure after we look at your setup. A 200 amp service is what modern homes need to safely run an EV charger, central air, a home office, and everything else at once.

Yes on both. Every tech is licensed through the Sedgwick County MABCD Electrical Board and fully insured. You have every right to ask any electrician for their license before they start, and you should. In Kansas, electricians earn a journeyman or master license only after around 4,000 hours of supervised work and a state exam on the National Electrical Code. If someone dodges that question, that is your answer right there.

We do. Call before noon and we usually get a same day electrician out to you. For the middle of the night stuff, sparking outlets, a burning smell, a panel that is buzzing, our 24 hour line is staffed by a real person. Kansas storm season keeps that line busy, so do not sit on a problem hoping it fixes itself. Call (316) 348 1390 and we will tell you straight how fast we can be there.

A breaker trips to protect you, so one trip that resets cleanly is fine. Repeated tripping means something is wrong. Usually it is too many things on one circuit, a failing appliance, damaged wiring, or a breaker that has simply worn out. In older Wichita homes it often traces back to an overloaded 100 amp panel that was never built for today's demands. Do not swap in a bigger breaker to make it stop. That removes your protection and creates a fire risk. Let a licensed electrician find the real cause.

For a lot of work, yes. New installations, service upgrades, panel replacements, generator hookups, meter base work, and major circuit additions all require a permit from MABCD, and the inspection that follows keeps you safe and on record. When you hire us, we handle the whole permit and inspection process so you never have to chase paperwork. Skipping permits can come back to haunt you when you sell.

Sometimes, sometimes not. A Level 2 charger usually needs a dedicated 40 to 50 amp circuit, and plenty of Wichita homes built before 2000 already run their 100 amp panel near its limit once you count the AC, water heater, and kitchen. We do a load calculation first to see what you actually have room for. If your panel is tapped out, we will tell you honestly, and a 200 amp upgrade opens the door for the charger plus whatever you add down the road.

It comes down to what you want running during an outage. A 12 to 15 kilowatt unit covers the essentials like the fridge, some lights, and the furnace blower. A 20 to 22 kilowatt generator runs most of the house, and larger homes with electric heat may need 26 kilowatts or more. We size it with a proper load calculation so you are not overpaying for capacity you will never use, or worse, coming up short during the next storm.

Often, yes. Knob and tube, cloth covered wiring, and aluminum branch circuits from the sixties and seventies were not built for the loads or the safety standards we live with now, and they are a common reason older homes fail an inspection. The same goes for Federal Pacific panels, which are known to be unreliable. We take a look, tell you whether a full rewire is truly needed or whether targeted fixes will do, and quote it plainly either way.

Under the code adopted here in Sedgwick County, GFCI outlets are required in bathrooms, kitchens, garages, laundry areas, outdoors, unfinished basements, and within six feet of any sink. AFCI protection is required in most living spaces like bedrooms, living rooms, and hallways. GFCIs guard against shock and AFCIs guard against the kind of arcing that starts fires. Missing GFCIs are the single most common thing we flag in older Wichita homes, and adding one usually takes under an hour.

Yes. Alongside our residential work, we take on commercial and industrial electrical projects, from tenant improvements and lighting systems to panel upgrades and new construction wiring. Commercial and industrial electrician work follows tighter standards for load calculations, conduit, and grounding, and we pull every required permit through MABCD and coordinate the inspections so your project stays on schedule and up to code from day one.